Scsi_transport_fc 44614 4 qla2xxx,libfc,tcm_qla2xxx,ocs_fc_lio when you do a modprobe r8125 does it load ? you can check with lsmod |grep -i r8125 Just add the one of the two modules (only the most required for install) then copy the usb r8152 module to /lib/modules and run : If an extension that has duplicate dependency tries to get loaded it will fail and will fail into recover/install mode. There is an issue with the extension loading mechanism. If I do NOT add the R8152 driver, it builds and loads fine and first try (but with only 1 working eth0 nic lan I hope you can read this and explain what adding the R8152 driver to an apollolake build causes this system to hang immediately after installing dsm7 and never actually loading into dsm?

pointing back to synoip I just get the welcome to diskstation message waiting to install dsm7 again. When the loader builds, it installs dsm7 and restarts and just hangs forever - monitor output shows starting usb kernel but hangs, never loads the hdds. rploader.sh ext add url command to add r8152 ext package (which it does download and add) but after building the loader it will not start in to dsm7 <- if I add the R8152 ext I then tried to rebuild the rploader with using the. In dsm6 that same realtek is using driver R8168, the other realtek is using driver R8152, and both working. In dsm7 however, only the pci realtek is used and shown having a driver (r8169) in dsm7, again no usb realtek, but dsm7 shows the only eth0 as a usb device. In the dsm6 it loads both realtek nic and shows drivers used for each. That post above has logs from both a dsm623 jun104b build and dsm701 rp046 loader build. (both ports work while in tinycore, and both have valid ip's while booted into tinycore) after building the apollolake loader, and installing and booting to dsm7, one 1 nic lan port works, while in dsm7 control panel>info center shows it as realtek r8153 usb device, but the ssh/terminal shows as only the pci realtek loaded and working. In dsm7 with rp046 loader, only 1 realtek nic lan port is working. One is on the PCI bus and one is USB bus, I think.

On this nas box, in dsm623 jun104b loader both nic lan ports are realtek.

Nas basic 48 loader 69 firmware update